Highpoint RocketRAID 3510 Guia do Utilizador Página 25

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 80
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 24
RocketRAID 3xxx BIOS Utility
3-2
Add/Remove Spare - this command is used to assign hard disks to function as
spare disks. The controller is capable of using spare disks to automatically rebuild
broken or faulted RAID arrays.
Section 3 discusses this command in detail.
Settings
Select Boot Device - this function is used to designate a particular disk or RAID array
to function as the RocketRAID 3xxx’s boot device.
Note: This setting is only relevant if the motherboard’s BIOS has set the
RocketRAID 3xxx to function as the system’s primary boot device.
Parameter Settings – various controller/device parameters
Staggered spinup – This function is used to enable (or disable) staggered
drive spin up support This setting, by default, is disabled.
Number of drives per spinup – informs the RocketRAID 3xxx how many
disks should be powered up simultaneously (when the Staggered spin up
feature is enabled).
Delay between spinup (seconds) – used to set the amount of time the
RocketRAID 3xxx will wait between issuing Staggered spinup commands.
Rebuild Priority – specify the RocketRAID 3xxx’s rebuild priority (resources
dedicated to rebuilding an array). There are five selections, ranging from
Lowest to Highest priority.
Spindown Idle Disk (MAID)Advanced HDD power management option. If
this option is enabled the idle hard disk will be set to standby mode auto-
matically and will be automatic wake up when HDD receive any regular
command.
Audible alarm – This setting is enabled by default. Used to enable/disable
the on card Buzzer alarm.
Auto rebuild – This setting is disabled by default. Used to enable/disable
automatic RAID rebuild and reconstruction for degraded array.
Single BCV Entry – Single Boot Connection Vector. Used to register RAID
adapter’s logical disks to System BIOS: “enable” only register first logical
Vista de página 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 79 80

Comentários a estes Manuais

Sem comentários