Highpoint RocketRAID 2640x4 Guia do Utilizador descarregar pdf (Página 60)

Linux(Fedora,Red Hat,SuSE) Driver Support

install the module, type in the following commands (first change directory to where the

proper rr26xx.ko locates):

#install –d /lib/modules/‘uname –r‘/kernel/drivers/scsi

#install –c rr26xx.ko /lib/modules/‘uname –r‘/kernel/drivers/scsi

#depmod

Then you should inform the system load the module when system boots up with the

following command:

#iecho “modprobe rr26xx” > /etc/init.d/hptdriver

#chmod 755 /etc/init.d/hptdriver

#ln –sf /etc/init.d/hptdriver /etc/rc.d/rc3.d/S01hptdriver

#ln –sf /etc/init.d/hptdriver /etc/rc.d/rc4.d/S01hptdriver

#ln –sf /etc/init.d/hptdriver /etc/rc.d/rc5.d/S01hptdriver

Step 4 Configure System to Mount Volumes when Startup

Now you can inform the system to automatically mount the array by modifying the file /

etc/fstab. E.g. you can add the following line to tell the system to mount /dev/sda1 to

location /mnt/raid after startup:

/dev/sda1 /mnt/raid ext2 defaults 0 0

4 - Monitoring the Driver

Once the driver is running, you can monitor it through the Linux proc file system

support. There is a special file under /proc/scsi/rr26xx/. Through this file you can view

driver status and send control commands to the driver.

Note:The file name is the SCSI host number allocated by OS. If you have no other

SCSI cards installed, it will be 0. In the following sections, we will use x to represent

this number.

Checking Devices Status

6-14

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 83 84

Sem comentários

Highpoint RocketRAID 2640x4 Guia do Utilizador Página 60